Kodak X-Omat 270 RA PROCESSOR Service Manual page 33

Caution
• Any obstruction such as biological growth, small bends, or an upward sloping WASH DRAIN HOSE can cause
wash water to return to the WASH TANK causing an overflow of water and damage to the ELECTRICAL BOX.
• Concentrations of chlorine bleach higher than 10% or allowing the chlorine bleach to remain in the
PROCESSOR for longer than 30 minutes can cause damage to the PROCESSOR.
[24] Check the WASH DRAIN for biological growth, small bends, or other obstructions. To remove biological
growth do the steps below:
(a) Fill the WASH TANK and DRAIN with a 10% solution of chlorine bleach.
(b) Wait a minimum of 20 minutes and a maximum of 30 minutes.
(c) Drain the chlorine bleach solution, and rinse the TANK and DRAIN thoroughly with water before
returning the PROCESSOR to normal use.
[25] Check the DRIVE CHAIN.
(a) If the DRIVE CHAIN is dry, apply lubricant to the DRIVE CHAIN. Use NLG1 - No. 2 LITHIUM BALL
and ROLLER BEARING GREASE TL-2324.
(b) If the DRIVE CHAIN is rusty, remove it and install a new DRIVE CHAIN.
(c) Adjust the tension of the DRIVE CHAIN. If necessary, see the procedure on Page 11.
SPRING
SPADE
[26] Check the SPRING SPADES on the LEVEL SENSOR PROBES for corrosion. If necessary, clean or install
new SPRING SPADES.
[27] Check the operation of the DETECTOR SWITCHES. If necessary, adjust the DETECTOR SWITCHES.
See the procedures on Page 25.
[28] Close the DRAIN VALVES and fill the processing TANKS with processing solutions and starter where
necessary.
[29] Energize the PROCESSOR.
[30] Process a test film and check the PROCESSOR for correct operation.
[31] Check the negative pressure at the EXHAUST VENT for the DRYER. See the Installation Instructions.
[32] Calibrate the REPLENISHMENT PUMPS. See the section "Calibrating the Replenishment System" in the
Operator Guide.
SM3058-3 – May 1996
Preventive Maintenance
H104_0383BCB
H104_0383BA
33