Procedure steps
1. Configure a single port SMLT by using the following command:
smlt <smltID>
Variable definitions
Use the data in the following table to help you use the smlt <smltid> command.
<smltid>
Enabling SMLT Interoperability with MSTP using ACLI
Use the following procedure to enable SMLT Interoperability for MSTP.
Prerequisites
• Configure your switch to MSTP mode.
• Configure an IST MLT.
Procedure steps
1. At the prompt, enter the following commands:
ist mlt <ID>
ist spanning-tree
Disabling SMLT Interoperability with MSTP using ACLI
Use the following procedure to disable SMLT Interoperability for MSTP.
Configuration — Link Aggregation, MLT, and SMLT
Variable
Enabling SMLT Interoperability with MSTP using ACLI
Value
Specifies the Split MLT ID. The value ranges
from 1–512.
January 2012
139