Configuring Lacp Parameters - Avaya 8600 Configuration Manual

SmltSysId

Configuring LACP parameters

Configure LACP parameters to manage LACP information.
Important:
Standby mode for aggregation groups of larger than eight ports is not supported in the
current release.
Procedure steps
1. In the navigation tree, open the following folders: Configuration > VLAN.
2. Click MLT/LACP
3. Click the LACP tab.
4. Click Apply.
Variable definitions
Use the data in the following table to help you configure the LACP parameters.
Index
MACAddress
Configuration — Link Aggregation, MLT, and SMLT
Variable
You can click fields to edit them but some fields are not editable.
Variable
The unique identifier allocated to this aggregator by the
local system. This attribute identifies an aggregator
instance among the subordinate managed objects of the
containing object. This value is read-only.
The six octet read-only value carrying the individual MAC
address assigned to the aggregator.
Value
Sets the LACP system ID for SMLT. This is an
optional parameter and is only used for SMLT
situations. You must configure the same LACP
SMLT system ID on both aggregation switches to
avoid loss of data. Avaya recommends that you
configure the SmltSysId so it matches the base
MAC address of one of the chassis.
The default value is 00:00:00:00:00:00.
Value
Configuring LACP parameters
January 2012 59