Avaya 8600 Configuration Manual page 126

Link aggregation configuration using the ACLI
Prerequisites
• You must log on to the Global Configuration mode in the ACLI.
Important:
Changes made at the global level override and reset all port level settings.
Procedure steps
1. Configure LACP globally by using the following command:
lacp
Variable definitions
The following table defines parameters that you enter after the lacp command.
aggr-wait-time <200–2000>
enable
fast-periodic-time <200–20000>
slow-periodic-time <10000–30000>
smlt-sys-id
<0x00:0x00:0x00:0x00:0x00:0x00>
system-priority <0-65535>
timeout-scale <2-10>
126 Configuration — Link Aggregation, MLT, and SMLT
Variable
Comments? infodev@avaya.com
Value
Sets the aggregation wait time (in milliseconds)
globally.
The default value is 2000.
Enables LACP globally. To disable LACP globally,
use the operator to remove this configuration.
no
To set this option to the default value, use the
operator with the command.
default
Sets the fast-periodic time (in milliseconds)
globally.
The default value is 1000.
Sets the slow periodic time globally.
The default value is 30000.
Sets the LACP system ID globally. Enter a MAC
address in the following format:
0x00:0x00:0x00:0x00:0x00:0x00.
Sets the global LACP system priority.
The default value is 32768.
Sets the timeout scale globally. The default value is
3. To set this option to the default value, use the
operator with the command.
default
January 2012