Chapter 9: Vlacp Configuration Using The Cli; Job Aid: Roadmap Of Vlacp Commands - Avaya 8600 Configuration Manual

Chapter 9: VLACP configuration using the
Configure Virtual LACP (VLACP) to implement link status control protocol at the port level. VLACP detects
for end-to-end failures in the Avaya Ethernet Routing Switch 8800/8600. Note that VLACP cannot
interoperate with LACP.

Job aid: Roadmap of VLACP commands

The following table lists the commands and their parameters that you use to complete the
procedures in this section.
config ethernet <portlist>
vlacp
show ports info vlacp [vlan
<value>] [port <value>]
config vlacp
Configuration — Link Aggregation, MLT, and SMLT
CLI
Command Parameter
disable
enable
ethertype <ethertype>
fast-periodic-time
<milliseconds>
info
macaddress <mac>
slow-periodic-time
<milliseconds>
timeout {long|short}
timeout-scale <integer>
disable
enable
info
hold-time <seconds>
January 2012 113