Viewing Lacp Configuration Information - Avaya 8600 Configuration Manual

Viewing LACP configuration information

View LACP configuration information to determine the LACP parameters and to ensure your
configuration is correct.
Prerequisites
• You must log on to the Privileged EXEC mode in the ACLI.
Procedure steps
1. View LACP configuration information by using the following command:
show lacp
Variable definitions
The following table defines optional parameters that you enter after the show lacp
command.
<cr>
actor-admin interface [{fastethernet|
gigabitethernet}] [vid {vlan-id[-vlan-id][,...]}]
[<portList>]
actor-oper interface [{fastethernet|
gigabitethernet}] [vid {vlan-id[-vlan-id][,...]}]
[<portList>]
Configuration — Link Aggregation, MLT, and SMLT
Variable
Viewing LACP configuration information
Value
Shows LACP global configuration
information.
Shows LACP actor administrative
information for all interfaces or the specified
interface.
• is the VLAN ID or list of VLAN
vlan-id
IDs to show only ports attached to a
particular VLAN. The range is 1–4094.
• is the port or port list.
portList
Shows LACP actor operational information
for all interfaces or the specified interface.
• vlan-id is the VLAN ID or list of VLAN
IDs to show only ports attached to a
particular VLAN. The range is 1–4094.
• is the port or port list.
portList
January 2012 129