Configuring An Ist Mlt - Avaya 8600 Configuration Manual

MLT and SMLT link aggregation configuration using Enterprise Device Manager
7. Click Ok.
8. Click Apply.

Configuring an IST MLT

Configure an IST MLT to add IST to MLT_LACP.
Procedure steps
1. In the navigation tree, open the following folders: Configuration > VLAN.
2. Click MLT/LACP
3. Click the MultiLink/LACP Trunks tab.
4. Click Insert.
5. In the PortMembers box for the IST MLT, click [...].
6. Click the ports you want to include in the IST MLT.
7. Click Ok.
8. In the MltType box, select istMLT.
9. In the PortType box, select trunk.
10. Configure the remaining boxes as required.
11. Click Insert.
12. Type the peer IP address and the VLAN ID in the box.
13. Select enable.
14. Click Apply.
74 Configuration — Link Aggregation, MLT, and SMLT
Important:
For Ethernet Routing Switch 8800/8600 modules, up to eight same-type ports
can belong to a single MLT.
The ports are added to the Port Members box on the MLTs tab.
The ports are added to the MLT-based SMLT.
The Port Editor: PortMembers dialog box appears showing the available ports.
The ports are added to the PortMembers box for the IST MLT in the Insert MLTs
tab.
The IST MLT dialog box appears.
Comments? infodev@avaya.com
January 2012