Barco Medea series Installation Manual page 40

Lenses
Image 5-2
1 Lens button.
2 Lens
Always activate the projector shutter before attempting to remove or install a lens.
To do this, press the shutter button on the keypad, or shutter Close on the remote, to activate the
shutter. The keypad button will illuminate red when the shutter is activated.
Press the shutter button again, or shutter Open on the remote, to deactivate the shutter and
resume normal operation. The keypad button will illuminate white when the shutter is deactivated.
Lens adapter
An optional lens adapter is available to reuse FLD and FLD+ lenses. The lens must be first mounted on the
lens adaptor then the assembly composed by the lens and the adapter could be used like a standalone lens.
Keep in mind that it is not possible to calibrate the shift while the lens adaptor is inserted. If shift-
calibration is needed , please remove lens adaptor first.
It is recommended to shift the lens holder close to its nominal position (vertical + horizontal).
Otherwise the internal rubber bellow of the lens holder can create some friction to the adapter outer
barrel.
The "turn and click" system to hold the lens on the adapter is similar to the mechanism to hold the standalone
lens on the projector. Align the lens (reference 2) with the adaptor (reference 3) and turn the lens to the right
(CW) until it is locked.
Image 5-3
40 R5906141 /02 Medea series