Installation Process Projector - Barco Medea series Installation Manual

Installation process

3.1 Installation process projector

Installation process from A to Z
1. Check if all installation requirements are fulfilled such as the environment conditions of the installation
area, electrical facilities, etc. For more info see "Installation requirements", page 20.
2. Decide in which configuration the projector will be mounted. For more details see "Projector
configurations", page 23.
3. Unpack the projector and confirm that all equipment is present and in good working order. See chapters
"Unpacking the projector", page 21 and "Initial inspection", page 23.
4. Mount the projector. For more details see chapter "Physical Installation", page 31.
5. Installation of the lens. First select a lens with appropriate throw ratio covering the screen size and the
projector - screen distance. Then install the lens in the lens holder of the projector. For more information about
available lenses, lens selection and lens installation see chapter "Lenses", page 37.
6. Connect the source. For more details see chapter "Input & Communication", page 49.
7. Power up the projector. See "Power on projector", page 59.
8. Adjust the system and setup the image. For more information about setup see chapter "Getting Started", page
57.
Note: Do not hesitate to refer to the user manual to obtain more information concerning the Graphical
User Interface (GUI).
30 R5906141 /02 Medea series