Projector Address; Controlling The Projector - Barco Medea series Installation Manual

Getting Started
Image 7-6: RCU to one of the IR sensors

7.9 Projector Address

Projector address
Address installed in the projector to be individually controlled.
Broadcast address
Projector will always execute the command coming from a RCU programmed with that broadcast
address.

7.9.1 Controlling the projector

Why a projector address?
As more than one projector can be installed in a room, each projector should be separately addressable with
an RCU or computer. Therefore each projector has its own address.
Set up an individual Projector Address
The set up of a projector address can be done via the software.
Projector controlling
When the address is set, the projector can be controlled now:
• with the RCU: only for addresses between 1 and 31.
Broadcast Address
Every projector has a broadcast (common) address '0' or '1'. The default address is '0'.
The choice between '0' and '1' can be selected in the GUI: "System Settings" → "Communication" →"IR Control
".
64 R5906141 /02 Medea series