Barco Medea series Installation Manual page 42

Lenses
1
Image 5-6
4. Turn the lens to right (CW) until it is locked (Image 5-6, Action arrow 2). A click indicates that the lens mount
mechanism is locked.
5. Verify that the lens is firmly in place (and the button is released) before removing your hand from the lens.
Remove a standalone lens
1. Support the lens with one hand.
2. Use the other hand to push the lens button in order to release the lens mount mechanism (Image 5-7, Action
arrow 1).
Note: The lens button needs to be kept pushed in until the lens has rotated about 10° with respect to
the lens holder.
2
1
Image 5-7
3. Turn the lens to the left (CCW) (Image 5-7, Action arrow 2).
4. Pull the lens straight out of the projector lens mount (Image 5-7, Action arrow 3).
5. Replace with another lens, or install the projector lens cap.
Install a lens with adaptor
1. Verify that the projector shutter is activated (shutter is activated when the shutter icon on the projector keypad
is red).
2. It is recommended to shift the lens holder close to its nominal position (vertical + horizontal). Otherwise the
internal rubber bellow of the lens holder can create some friction to the adapter outer barrel. Please refer to
the section dedicated to the "lens shift" in the User manual to correct the lens holder position if it is necessary.
3. Make sure to remove all protective caps present on the lens, lens adapter and lens holder.
4. Align the lens top marking (red) with the top marking on the lens adapter and insert the lens (Image 5-8, Action
arrow 1).
42 R5906141 /02 Medea series
2
3