View Configured Setpoint Values; Reset Configuration - Rice Lake Revolution 680 Synergy Plus Technical Manual

3.4.18 View Configured Setpoint Values

See Section 9.0 on page 55
1. Press . audit displays.
2. Press twice. Setpnt displays.
3. Press . The lowest configured setpoint number displays.
4. Press to navigate to the desired setpoint number (1-8).
Only configured setpoint numbers display. Displayed setpoints are read only unless access is set to on.
Note
See Section 4.4.8 on page 35
5. Press . value displays.
6. Press again to view the current configured setpoint value.
7. To edit the setpoint value use the following method:
• Press to clear the current value
• Use the numeric keypad to enter the new value and press
• Press to accept the new value once correct
8. Press to return to weigh mode.

3.4.19 Reset Configuration

1. Access setup mode by pressing the setup switch
2. Press . dfltcfg displays.
3. Press . no displays.
4. Press . yes displays.
5. Press or
6. Press or
7. Press to return to weigh mode.
more information.
for the complete setpoint menu.
to reset the configuration setting. ok displays.
. no displays again.
to accept it
(Figure 4-1 on page 22). Config displays.
© Rice Lake Weighing Systems ● All Rights Reserved
Operation
21