View And Edit Date Value; View Configured Setpoint Values; Reset Configuration - Rice Lake Synergy 680HE Technical Manual

680HE Synergy Indicator

3.4.17 View and Edit Date Value

To view and edit the current date:
1. Press . audit displays.
2. Press multiple times until date displays.
3. Press to view the current set date.
4. To edit the date value use the following method:
• Press to clear the current date
• Use the numeric keypad to enter the new date value and press
5. Press to return to weigh mode.
Date is backed up by the internal battery and is not lost if the main power is interrupted.
Note
See Section 4.4.5 on page 30

3.4.18 View Configured Setpoint Values

See Section 9.0 on page 55
1. Press . audit displays.
2. Press twice. Setpnt displays.
3. Press . The lowest configured setpoint number displays.
4. Press to navigate to the desired setpoint number (1-8).
Only configured setpoint numbers display. Displayed setpoints are read only unless access is set to on.
Note
See Section 4.4.8 on page 35
5. Press . value displays.
6. Press again to view the current configured setpoint value.
7. To edit the setpoint value use the following method:
• Press to clear the current value
• Use the numeric keypad to enter the new value and press
• Press to accept the new value once correct
8. Press to return to weigh mode.

3.4.19 Reset Configuration

1. Access setup mode via the setup jumper
2. Press . dfltcfg displays.
3. Press . no displays.
4. Press . yes displays.
5. Press or
6. Press or
7. Press to return to weigh mode.
20 Visit our website
for date formatting options.
more information.
for the complete setpoint menu.
(Figure 4-1 on page
to reset the configuration setting. ok displays.
. no displays again.
www.RiceLake.com
to accept the desired value
to accept it
21). Config displays.