Display Or Change Setpoint Value; Turn Setpoint On Or Off; Print Ticket - Rice Lake Revolution SURVIVOR 420HE Installation Manual

Sub Menu
– Press and hold UNITS key for three seconds
SETPNT
SETPT1
ENABLE
OFF
ON
NOTE: Only Available when ACCESS = ON
See Figure 3-11 on page 23 and Table 3-7
on page 24 for more information.
1.4.8

Display or Change Setpoint Value

To display a setpoint value, enter front panel setup mode. Press
keys toggle through both setpoints if operator accessible. Press
RIGHT
/ keys to toggle to
LEFT RIGHT
Note
Setpoint Value, Band Value and Hysteresis can be accessible from the front panel in the weigh mode.
To change the setpoint value, use the
digit. Press to move to the decimal point entry.
ENTER
the key to accept the displayed value and return to the next value or setpoint number prompt. Press the
ENTER
key until is displayed. Press the
SETPNT
1.4.9

Turn Setpoint On or Off

To turn a setpoint on or off at the front panel, enter front panel setup mode. Press
.The
SETPT1 LEFT/RIGHT
is displayed. Press
ENABLE
displayed. Press once more to exit.
UP
1.4.10

Print TIcket

1. Wait for standstill annunciator (
2. Press the key to send data to the serial port.
PRINT
SETPT2
Same as SETPT 1
BNDVAL
V ALUE
number
number
Figure 1-2. Front Panel Setpoint Setup
. Press
VALUE DOWN
keys to increment/decrement the decimal value of the flashing
UP/DOWN
key once more to exit. See Figure 1-2.
UP
keys toggle through each setpoint that is operator accessible. Press
or to turn the setpoint
RIGHT LEFT
).
T/DATE
DATE
010104
HYSTER
number
or
DOWN
DOWN
or to view the value. See Figure 1-2.
ENTER
keys adjust the decimal point placement. Press
LEFT/RIGHT
or
ON OFF
TIME
0000
NOTE: The indicator will begin
incrementing time at power up.
to display
ENTER SETPT1
or to display
ENTER
ENABLE
or again to display
DOWN ENTER
DOWN
. Press the key until
UP
. The
LEFT/
. Use the
UP
or and
ENTER
is
SETPNT
5