Mahindra Bolero Maxitruck Plus BS III 2013 Diagnostic Manual page 165

DIAGNOSTIC MANUAL
STEP 2
Check and verify the last fuel
filter change kilometers
STEP 3
Carry out the fuel system
bleeding at the injector nuts
Check and verify for the DTC
STEP 4
Replace the fuel filter with a
new one
Check and verify for the DTC
STEP 5
Clean the fuel strainer and fuel
lines
Check and verify for the DTC
Go to STEP 6
The repair methods given by the manufacturer in this document are based on the technical specifications, current at the time of release. The methods may be modified as a result of changes introduced by the
manufacturer in the production of the various component units and accessories from which the vehicles are manufactured. The reproduction, translation, transmission, in part of or whole of the present document,
are prohibited without the prior written consent of Mahindra & Mahindra Ltd. The use of this document by any person other than the trained personnel, at the Authorized Service Centre of Mahindra & Mahindra Ltd.,
will amount to unauthorized use and shall be liable for penalty/prosecution© 2013 Mahindra & Mahindra Ltd.
EMS
STEP 1
Connect the smart tester
Turn the ignition ON
Initialise the diagnostic tool
Record the DTC and clear
Turn ignition OFF
Turn ignition ON
Verify if P1B87 is present?
Is P1B87 present?
Is the DTC registered in
< 2000 kms after fuel
filter change?
Is the DTC still
present?
Is the DTC still
present?
Is the DTC still
present?
MAN-00226
MAY 2013/Rev 1
P 1B87
Intermittent problem exists
Refer the intermittent problem
inspection procedure
Replace the fuel filter with anew
one
Clear the DTC and verify
Diagnosis completed
Diagnosis completed
Diagnosis completed
164