Mahindra Bolero Maxitruck Plus BS III 2013 Diagnostic Manual page 72

DIAGNOSTIC MANUAL
STEP 2
Check the voltage between pin
4 of the fuel temperature
sensor wiring harness
connector and battery ground
STEP 3
Check the continuity between
pin 4 of the fuel temperature
sensor wiring harness
STEP 4
connector and battery ground
Suspect EMS ECU malfunction
Replace EMS ECU with a new
one.
Check and verify for any new
DTC's
The repair methods given by the manufacturer in this document are based on the technical specifications, current at the time of release. The methods may be modified as a result of changes introduced by the
manufacturer in the production of the various component units and accessories from which the vehicles are manufactured. The reproduction, translation, transmission, in part of or whole of the present document,
are prohibited without the prior written consent of Mahindra & Mahindra Ltd. The use of this document by any person other than the trained personnel, at the Authorized Service Centre of Mahindra & Mahindra Ltd.,
will amount to unauthorized use and shall be liable for penalty/prosecution© 2013 Mahindra & Mahindra Ltd.
EMS
STEP 1
Connect the smart tester
Turn the ignition ON
Initialise the diagnostic tool
Record the DTC and clear
Turn ignition OFF
Turn ignition ON
Verify if P0182 is present?
Is P0182 present?
Is the value =5 ±
0.25 V?
Is the continuity
exists?
MAN-00226
MAY 2013/Rev 1
P 0182
Intermittent problem exists
Refer the intermittent problem
inspection procedure
Go to STEP 4
Examine the short circuit of
fuel temperature sensor signal
wire to ground
Replace the wiring harness
Clear the DTC and verify
71