Mahindra Bolero Maxitruck Plus BS III 2013 Diagnostic Manual page 152

DIAGNOSTIC MANUAL
STEP 11
Check the continuity between
pin 6 and pin 5 of accelerator
pedal wiring harness connector
Suspect accelerator pedal
sensor internal failure
Replace accelerator pedal with
a new one.
Check and verify for any new
DTC's
The repair methods given by the manufacturer in this document are based on the technical specifications, current at the time of release. The methods may be modified as a result of changes introduced by the
manufacturer in the production of the various component units and accessories from which the vehicles are manufactured. The reproduction, translation, transmission, in part of or whole of the present document,
are prohibited without the prior written consent of Mahindra & Mahindra Ltd. The use of this document by any person other than the trained personnel, at the Authorized Service Centre of Mahindra & Mahindra Ltd.,
will amount to unauthorized use and shall be liable for penalty/prosecution© 2013 Mahindra & Mahindra Ltd.
EMS
STEP 10
Check the continuity between
pin 4 and pin 3 of accelerator
pedal wiring harness connector
I
Is the continuity
exists?
I
Is the continuity
exists?
MAN-00226
MAY 2013/Rev 1
P 2138
Examine the short circuit of
accelerator pedal sensor 1
signal wire with battery ground
Repair/replace the wiring
harness
Clear the DTC and verify
Examine the short circuit of
accelerator pedal sensor 2
signal wire with battery ground
Repair/replace the wiring
harness
Clear the DTC and verify
151