Sensor Supply Voltage 2 Monitoring Error - Mahindra Bolero Maxitruck Plus BS III 2013 Diagnostic Manual

DIAGNOSTIC MANUAL
P0651
SENSOR SUPPLY VOLTAGE 2 MONITORING
EMS ECU monitors the reference voltage of Accelerator Pedal position sensor 2 (APP2) and
registers a DTC if the voltage is not within the range.
NORMAL OPERATION

Ignition ON

EMS ECU monitors the reference voltage of Accelerator Pedal
position sensor 2 (APP2) and is within the range
DTC DETECTING CONDITIONS

Ignition ON

EMS ECU supply voltage 8-16V

The supply voltage of Accelerator Pedal position sensor 2
(APP2) is out of the range
DTC REACTIONS

Nil
HEALING CONDITION

Ignition Off/On
The repair methods given by the manufacturer in this document are based on the technical specifications, current at the time of release. The methods may be modified as a result of changes introduced by the
manufacturer in the production of the various component units and accessories from which the vehicles are manufactured. The reproduction, translation, transmission, in part of or whole of the present document,
are prohibited without the prior written consent of Mahindra & Mahindra Ltd. The use of this document by any person other than the trained personnel, at the Authorized Service Centre of Mahindra & Mahindra Ltd.,
will amount to unauthorized use and shall be liable for penalty/prosecution© 2013 Mahindra & Mahindra Ltd.
EMS

SENSOR SUPPLY VOLTAGE 2 MONITORING ERROR

DTC INFORMATION
MAN-00226
MAY 2013/Rev 1
PROBABLE CAUSES OF FAILURE

Short to ground /battery of
supply wire APP2

Faulty APP2 (Accelerator
Pedal)
159