Sensor Supply Voltage1 Monitoring Error; Connector Information - Mahindra Bolero Maxitruck Plus BS III 2013 Diagnostic Manual

Table of Contents

DIAGNOSTIC MANUAL

P0641

SENSOR SUPPLY VOLTAGE 1 MONITORING

EMS ECU monitors the reference voltage of the Boost pressure sensor ,Rail pressure sensor,Clutch

sensor,Vehicle speed sensor and Camshaft sensor and registers a DTC if the voltage is not within the

range.

NORMAL OPERATION



Ignition ON



EMS ECU monitors the reference voltage of the Boost

pressure sensor ,Rail pressure sensor,Clutch sensor,Vehicle

speed sensor and Camshaft sensor and are within the range

DTC DETECTING CONDITIONS



Ignition ON



EMS ECU supply voltage 8-16V



The sensor supply voltage of Boost pressure sensor ,Rail

pressure sensor,Clutch sensor,Vehicle speed sensor and

Camshaft sensor are out of the range

DTC REACTIONS



Engine Check lamp continuously ON



Engine will not start

HEALING CONDITION



Ignition Off/On

CONNECTOR INFORMATION

CONNECTOR DESCRIPTION

VEHICLE SPEED SENSOR

RAIL PRESSURE SENSOR

BOOST PRESSURE SENSOR

CLUTCH SENSOR

CAMSHAFT SENSOR

The repair methods given by the manufacturer in this document are based on the technical specifications, current at the time of release. The methods may be modified as a result of changes introduced by the

manufacturer in the production of the various component units and accessories from which the vehicles are manufactured. The reproduction, translation, transmission, in part of or whole of the present document,

are prohibited without the prior written consent of Mahindra & Mahindra Ltd. The use of this document by any person other than the trained personnel, at the Authorized Service Centre of Mahindra & Mahindra Ltd.,