Configuring A New Head; Hardware Setup Showing The Configuration Of A Multichannel Pod - Beckman Coulter Biomek NX User Manual

Configuring the Biomek NX Multichannel in Biomek Software
Configuring a Multichannel Pod

Configuring a New Head

When a head on a Multichannel Pod is changed, the
CAUTION
If the hardware configuration is not updated using Hardware Setup, hardware
crashes or inaccurate liquid transfer may occur.
CAUTION
To avoid hardware crashes, a new D-axis limit must be established and the gripper
framed in the Biomek Software after the head has been configured in Hardware
Setup.
To change the head on a Multichannel Pod (refer to
Hardware Setup according to the following instructions.
1
In
Hardware Setup
2
Change the
3
Choose the appropriate head in
Figure 2.2 Hardware Setup showing the configuration of a Multichannel Pod
2-4
, select the .
Pod
to correspond to the serial number on the new head.
Serial Number
Head Type
must be changed appropriately.
Hardware Setup
CHAPTER 1, Changing
(Figure 2.2).
Heads) and then configure
987892AF