Beckman Coulter Biomek NX User Manual page 91

9
Choose
Setting Delta Values for the Pod
A value is the amount of change in an axis that is applied to the
Delta
button in the
clicked in the
NOTE
The move does not occur until Go is selected in the Movement Vector area of Advanced Manual
Control.
To set
Delta
1
Choose
2
Choose
3
Select
Pod1
4
Enter a value in
5
In
D Units
6
Choose
7
Choose
Understanding and Using the Vector Builder
The use of
Advanced Manual Control
movement vectors. A movement vector simply indicates the magnitude and direction of motion
applied to the pod.
Use the
Vector Builder
for the pod. Each time a
Vector
or subtracted from the appropriate
front and center of the unit, positive and negative values for the pod are as follows:
987892AF
to close
Exit Manual Control
is pressed. For example, if the
Vector Builder
, 3 cm is added to the X axis of the
Vector Builder
values:
Instrument > Manual Control
.
Advanced Controls
.
Advanced Manual Control
, , , and to set the
X Y Z D
, select or .
cm μL
to close
Close Advanced Manual Control
to close
Exit Manual Control
for the pod centers around the building and applying of
buttons (Figure
Vector Builder
Movement Vector
Manually Controlling the Biomek NX in Biomek Software
.
Delta
Movement Vector
. appears
Manual Control
for the pod appears (Figure
value for each axis.
Delta
.
.
4.6) to add positive or negative values to the
button is pressed, the
for the pod. With the point of reference at the
Using Advanced Manual Control
when a
Movement Vector
value for is 3, each time
X
.
(Figure 4.2).
4.5).
Movement
value for that axis is added
Delta
4
is
Right
4-9