Multiple Helixes (Master / Slave Control) - SHOWTEC Helix M1000 Q4 Mobile Manual

Helix M1000 Q4 Mobile

Multiple Helixes (Master / Slave Control)

01) Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Always use a safety cable (ordercode 70140 / 70141).
03) Plug the end of the electric mains power cord into a proper electric power supply socket.
04) For the light output to be visible, press the power switch ON/OFF (08). The current from the built-in
battery is responsible for the light output. The True1 pro power cable should be used only when
charging the battery.
05) Use a 5-pin XLR cable to connect the Helix.
The pins:
06) Link the units as shown in Fig. 10. Connect a DMX signal cable from the first unit's DMX "out" socket to
the second unit's "in" socket. Repeat this process to link the second and third units. Press the power
switches ON/OF (08) on all slave devices, for the light output to be visible. You can use the same
functions on the master device as described on pages 26–27. This means that you can set your
desired operation mode on the master device and all slave devices will react the same as the
master device.
Multiple Helixes (Master/Slave Set Up)
Ordercode: 43740
01)
Earth
02)
Signal (-)
03)
Signal (+)
04)
N/C
05)
N/C
14
Fig. 10