Dmx Sync; Lock; Calibration - SHOWTEC Helix M1000 Q4 Mobile Manual

Helix M1000 Q4 Mobile
Note: After the working time is set, the maximum operating power of the device will be limited,
according to the current capacity of the battery, to achieve the set working time.
However, if the capacity of the battery is too low, the set time is too long and the working time is not
sufficient, then it will run at the minimum power, and the specific time will be shorter than the set time. If
the battery capacity is sufficient to perform for the desired amount of time, the device will run at the
maximum power, and the working time is uncertain, which may be longer than the set time.

6.5. DMX Sync

With this menu you can set the devices' behavior, while using multiple Helixes.
01) Press the UP/DOWN buttons to select ON (all Helix devices will simultaneously perform the same
action, without any delays) or OFF (risk of random delays).
02) Press the SET button to confirm your choice.

6.6. Lock

With this menu you can set the safety lock, restricting access to the main menu.
01) Press the UP/DOWN buttons to select one of the 2 options:
● ON: When no button is pressed within 30 seconds, the device's main menu will be locked.
In order to unlock it, press and hold down the MODE and SET buttons for 3 seconds.
● OFF: Safety lock is inactive.
02) Press the SET button to confirm your choice.

6.7. Calibration

With this menu you can manually calibrate the desired color.
01) Press the UP/DOWN buttons to choose one of the 4 colors you want to calibrate: Red, Green, Blue
and White.
02) Press the SET button to enter the menu.
03) Press the UP/DOWN buttons to set the intensity of the LEDs. The adjustment range for each color is
between 0–255, from dark to brightest.
04) Press the SET button to save your settings.
05) You can combine Red, Green, Blue and White to create an infinite range of colors (0–255).
Ordercode: 43740 30