Table of Contents
Advertisement
Helix M1000 Q4 Mobile
Installation
Remove all packing materials from the Helix M1000 Q4 Mobile. Check that all foam and plastic padding
is removed. Connect all cables.
Do not supply power before the whole system is set up and connected properly.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Installing the Beamshapers (43745/43746/43747)
01) In order to install the Beamshaper, place it on the lens of the Helix. The Beamshaper is equipped with
multiple magnets which keep it firmly in position.
02) For extra safety, use a safety cable to connect the Beamshaper to the Helix.
Fig. 03
Ordercode: 43740
10
Advertisement
Table of Contents
