Table of Contents
Advertisement
Helix M1000 Q4 Mobile
Multiple Helixes (DMX Control)
01) Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Always use a safety cable (ordercode 70140 / 70141).
03) Plug the end of the electric mains power cord into a proper electric power supply socket.
04) Use a 5-pin XLR cable to connect the Helix and other devices.
05) Link the units as shown in Fig. 11. Connect a DMX signal cable from the first unit's DMX "out" socket to
the second unit's "in" socket. Repeat this process to link the second and third units.
06) Supply electric power: Plug electric mains power cords into each unit's True1 pro socket, then plug
the other end of the mains power cord into proper electric power supply sockets, starting with the
first unit. Press the power switch ON/OF buttons (08) on all Helix devices, for the light output to be
visible. Do not supply power before the whole system is set up and connected properly.
Multiple Helixes (DMX Set Up)
Ordercode: 43740
Note: Link all cables before connecting electric power!
15
Fig. 11
Advertisement
Table of Contents
