Figure 9-3 Example Configuration 1 - Static Ip Addressing, One Lan - NEC Sl2100 Networking Manual

ISSUE 1.0
Chassis
NEC SL2100
VoIPDB IP Address
192.168.1.20
VoIP DSP:
Subnet Mask:
Default Gateway: 192.168.1.254

Figure 9-3 Example Configuration 1 - Static IP Addressing, One LAN

Programming - CPU:
10-12-01 : CPU Network Setup - IP Address (for CPU)
10-12-10 : CPU Network Setup - Subnet Mask
10-12-03 : CPU Network Setup - Default Gateway
10-12-09 : CPUNetwork Setup - VoIPDB IP Address
(This assignment is for CPU-C1 when the VoIPDB daughter board is installed.)
Programming - VoIP DSP Resource:
84-26-01 : VoIP Basic Setup - IP Address (Slot # - DSP)
Programming - IP Phones:
DHCP Mode
IP Address
Subnet Mask
Default Gateway
1st Server Address
1st Server Port
6.2 Example Configuration 2 - Dynamic IP Addressing, One LAN
This example shows System IP Phones connected to a single LAN (no routers) with dynamic IP
Addresses. The DHCP server could be:
• Customer supplied (e.g., Windows server)
• inDHCP internal DHCP server
In this case, additional programming would be required. Refer to
page 4-1.
Networking Manual
CPU-C1
VoIP
192.168.1.21
255.255.255.0
192.168.1.200
Extension: 100
PoE Switch
IP Phone 1 IP Phone 2
192.168.1.201
Extension: 101
0.0.0.0
255.255.255.0
192.168.1.254
192.168.1.20
192.168.1.21
Disabled
192.168.1.200
255.255.255.0
192.168.1.254
192.168.1.20
5080
General IP Configuration on
SL2100
9-5