NEC Sl2100 Networking Manual page 41

ISSUE 1.0
Item Item
No.
40 Calling name dis-
play info via
trunk for stand-
ard SIP
41 Time Zone(hour)
42 Time Zone(mi-
nute)
43 Video Mode
44 Using STD-SIP
Display for CPN
45 NAT plug & play
46 Door Phone
Number
47 Registration Ex-
pire Timer for
NAT
48 Subscriber Ex-
pire Timer for
NAT
49 Receiving SIP IN-
FO
50 Peer to Peer
Mode
51 Transport Proto-
col
Networking Manual
Input Data
0 = Both name and Trunk name is the first priority and
*
number abbreviated (SPD) name is second
1 = Name only priority
2 = Number only
3 = None
0 ~ 24
(- 12 ~ + 12 hour)
0 ~ 120
(- 60 ~ + 60 minute)
0 = Disable
1 = Enable
0 = Disable
1 = Enable
0 = OFF Effect this program only when PRG
1 = ON 10-46-14 (for IP Multiline Terminals)
or PRG 10-33-05 (for Standard SIP
Terminal) are set to NAT mode.
Effect this program only when PRG
10-46-14 (for IP Multiline Terminals)
is set to NAT mode.
If you are setting the SIP Terminal
using remote router by turning this
setting ON you don't need to set the
Port Forward on remote router side.
Select sending RTP port number to
remote Router, use from negotiation
result (0) or received RTP packet (1)
0 = Not door phone
1 ～ 6 = Door phone
number
0 = Disable On a per station basis, this setting
60 ~ 65535 (sec) defines the SIP registration expiry
timer. This setting applies to IP Mul-
tiline Terminals or Standard SIP Ter-
minal connected via NAPT. If this
value is set to 0, for a NAPT termi-
nal, the value in PRG 84-23-01 (for
IP Multiline Terminals) or PRG
10-33-01 (for Standard SIP Termi-
nal) are applied.
0 = Disable On a per station basis, this setting
60 ~ 65535 (sec) defines the SIP subscribe expiry
timer. This setting only applies to IP
Multiline Terminals or Standard SIP
Terminal connected via NAPT. If this
value is set to 0, for a NAPT termi-
nal, the value in PRG 84-23-02 (for
IP Multiline Terminals) or PRG
10-33-01 (for Standard SIP Termi-
nal) are applied.
0 = Disable Enables to receive a SIP INFO mes-
1 = Allowed any time sage from a standard SIP phone as
2 = Allowed while RTP a dial information.
is not available
0 = Off
1 = On
0 = UDP This program is the transport proto-
1 = TCP col. (Read only)
Description Default
SL2100
Related
Program
0
12
60
0
Program
0
15
1 10-46-14
0
180 84-23-01
180 84-23-02
1
1
0
5-21