Figure 9-35 8Ipld Server Information Setup - NEC Sl2100 Networking Manual

ISSUE 1.0
Network Settings
• DHCP Mode - DHCP Disable. Click OK.
• IP Address - Enter the IP Address for the station, and click OK.
• Default Gateway - Enter the Default Gateway Address, and click OK. If you are testing without a
router/gateway, this must be left at the default 0.0.0.0.
• Subnet Mask - Enter the Subnet Mask for the station, and click OK.
SIP Settings
• SIP User
- User ID - Enter User ID assigned in command 84-22. Click OK.
- Password - Enter the password assigned in command 84-22. Click OK.
- Incom Number - Enter the extension number for the IP station. Click OK.
• Server Address & URI - 1
Enter the IP address assigned in command 10-12-09, and click OK.
• SIP Server Port - 1 st
Enter port 5080. Click OK.
• Press the EXIT key until you are back at the Main menu.
• Press the SAVE key, and the phone saves the configuration to memory, reboots itself and registers
with the CPU.
13.10.3 Manual Registration
Steps 1~4 are the same as for Section
1. Same as for Automatic Registration Mode.
2. Same as for Automatic Registration Mode.
3. Same as for Automatic Registration Mode.
4. Same as for Automatic Registration Mode.
5. Program10-46 – ChangeProgram10-46-01 to Manual.
6. Same as for Automatic Registration Mode.
7. Same as for Automatic Registration Mode.
Networking Manual
st
Server Address
Server Port
Automatic Registration on page

Figure 9-35 8IPLD Server Information Setup

SL2100
9-41.
9-43