NEC Sl2100 Networking Manual page 77

ISSUE 1.0
6.3 SIP Caller ID
Program/Item
No.
14-01-24 Basic Trunk Data Setup –
Trunk-to-Trunk Outgoing Caller
ID Through Mode
21-17-01 IP Trunk (SIP) Calling Party
Number Setup for Trunk
21-19-01 IP Trunk (SIP) Calling Party
Number Setup for Extension
6.4 SIP CODEC Trunk
Program/Item
No.
84-13-01 SIP Trunk CODEC Information
Basic Setup – G.711 Audio
Frame Number
84-13-02 SIP Trunk CODEC Information
Basic Setup – G.711 Voice Ac-
tivity Detection Mode
84-13-03 SIP Trunk CODEC Information
Basic Setup – G.711 Type
84-13-04 SIP Trunk CODEC Information
Basic Setup - G.711 Jitter Buf-
fer (min)
84-13-05 SIP Trunk CODEC Information
Basic Setup – G.711 Jitter Buf-
fer (average)
Networking Manual
Description/
Selection
0 = Disable
1 = Enable
Default = 0
1 ~ 0, *, # (to equal up to 16 digits)
Default not assigned
1 ~ 0, *, # (to equal up to 16 digits)
Default not assigned
Description/
Selection
1 = 10ms
2 = 20ms
3 = 30ms
4 = 40ms
Default is 2
0 = Disable
1 = Enable
Default is 0
0 = A-law
1 = μ-law
Default is 1
0 ~ 255ms
Default is 20
0 ~ 255ms
40ms = Default is 40
Assigned Data
Select SIP Profile 1-6.
Assigned Data
Select SIP Profile 1-6.
Select SIP Profile 1-6.
Select SIP Profile 1-6.
Select SIP Profile 1-6.
Select SIP Profile 1-6.
SL2100
Comments
Enable/Disable the Trunk-to-
Trunk Outgoing Caller ID
Through Mode. This option al-
lows Caller ID from the original
outside caller to be displayed
when a trunk is forwarded off
premise. This option can be used
only with PRI and SIP trunks.
This program assigns the Caller
Party Number for each IP trunk.
The assigned number is sent to
the central office when the caller
places an outgoing call. If the
Calling Party Number is assigned
by both 21-17 and 21-18/21-19,
the system uses the entry in
21-18/21-19.
Assign the Calling Party Number
for each extension. The assigned
number is sent to the central of-
fice when the caller places an
outgoing call. If the Calling Party
Number is assigned by both Pro-
gram 21-17 and 21-18/21-19, the
system uses the data in Program
21-18/21-19.
Comments
Set the G.711 Audio Frame Num-
ber.
Enable/Disable the G.711 VAD
Detection Mode.
Define the G.711 type.
Set the minimum G.711 Jitter
Buffer.
Set the average G.711 Jitter Buf-
fer.
7-9