Section 5 Aspirenet Example - NEC Sl2100 Networking Manual

Hide thumbs Also See for Sl2100:
Table of Contents

Advertisement

SL2100
S
5 ASPIRENET EXAMPLE
ECTION
The examples in this section are only a guide to the configuration required on the SL2100 to install
AspireNet Operation.
5.1 AspireNet - IP
5.1.1 VoIP Networking Example
AspireNet IP requires the VOIPDB Blade and SL2100 Networking License. The VOIPDB Blade
provides the speech resources.
The example below shows two SL2100 systems, each has a VOIPDB Blade installed. The VOIPDB
Blades are connected to a hub via a standard LAN patch cable. SL2100 A has extension numbers in
the range 200-299, SL2100 B has 300-399.
SL2100 A
SL2100 A
Program 10-12-09
IP Address of the VOIPDB = 172.16.0.10
Program 10-12-10
Subnet Mask = 255.255.0.0
Program 10-19-01
DSP Resource is assigned for the Network.
= 3
Program 10-20-01
TCP Port Setup Device 4 = 30000
Program 10-27-01
Destination IP Address and port number for each ID
ID 1 = IP Address 172.16.5.10
Procedure port must be set to 1730
Program 11-01-01
System Numbering
Dial 2x = 3 digit, Type 2 (Intercom)
Dial 3x = 3 digit, Type 8 (Networking), ID = 1
Program 84-02-35
Enable Fast Start
Program 84-34-01 (Type = 2, Profile = 1)
DTMF Relay Mode 1 = RFC2833
Program 84-26-01
IP address for each DSP
172.16.0.20
Explanation of routing for IP AspireNet
When a user places a call to a remote extension number the dialed digits are checked against the
Numbering Scheme in Program 11-01. This will provide the Node ID number of the route to the remote
13-30
Hub
VOIPDB
VOIPDB
Program 10-12-09
IP Address of the VOIPDB = 172.16.5.10
Program 10-12-10
Subnet Mask = 255.255.0.0
Program 10-19-01
DSP Resource is assigned for the Network.
= 3
Program 10-20-01
TCP Port Setup Device 4 = 30000
Program 10-27-01
Destination IP Address and port number for each ID
ID 1 = IP Address 172.16.0.10
Procedure port must be set to 1730
Program 11-01-01
System Numbering
Dial 2x = 3 digit, Type 8 (Networking), ID=1
Dial 3x = 3 digit, Type 2 (Intercom)
Program 84-02-35
Enable Fast Start
Program 84-34-01 (Type = 2, Profile = 1)
DTMF Relay Mode 1 = RFC2833
Program 84-26-01
IP address for each DSP
172.16.5.20
ISSUE 1.0
SL2100 B
SL2100 B
AspireNet

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents