NEC Sl2100 Networking Manual page 156

SL2100
1.2 SL2100 Requirements
The following information provides requirements for NAPT.
Main Software
NAPT is supported with the V1.00 or higher release of the SL2100.
Hardware
The SL2100 requires the following hardware:
• CPU (V1.00 or higher)
• VoIP Daughter Board
Capacity
A maximum of 112 IP phones can be connected.
1.3 Installation
The following settings have been added for NAT traversal in the 8IPLD IP Terminal.
To enter IP phone programming at the terminal, press HOLD, TRANSFER, *, #. User name is ADMIN
and password is 6633222 (NEC).
1.3.1 Settings for terminals
Setting location: 0. Config/ 2. SIP Settings/ 8. NAT Traversal
Number and Setting Val-
Name of Set- ue
ting
1. NAT Traver- 1. Disable
sal Mode 2. Dynamic
3. Static
2.Network Area A character
Name string
3.WAN Settings
Setting location: 0. Config/ 2. SIP Settings/ 8. NAT Traversal/ 3. WAN Settings
Number and Setting Value
Name of Set-
ting
1. WAN Mate IP IP Address
Address
2. WAN SIP Mate 1024~65535
Port
3. WAN Self IP IP Address
Address
11-2
Default Factory
Value Value
1. Disable Available Available
No value Available Available
Default Factory
Value Value
0.0.0.0 Available
5060 Available
0.0.0.0 Available
Auto Con-
fig
Settings for NAT Traversal:
Disable: Disables NAT Traversal
Dynamic: Performs NAT Traversal using a dy-
namic conversion table.
Static: Performs NAT Traversal using a static
conversion table and requires the WAN IP Ad-
dress to be entered into the IP Terminal.
The name of the network area to which termi-
nals belong. Specify up to 32 alphanumeric
characters. Step is optional.
See table below.
Auto Config
Available WAN Address of the router that the SL2100
resides behind. This setting must match
what is programmed in PRG 10-12-07.
Available Port number the SL2100 uses for SIP reg-
istration in PRG 10-46-06.
Available Only used when Static NAT is enabled.
This setting is the WAN address of the
router that the NAPT Terminal resides be-
hind.
ISSUE 1.0
Description
Description
NAPT