NEC Sl2100 Networking Manual page 153

ISSUE 1.0
Program Program Name
Number
10-37-01 UPnP Setup – UPnP
Mode
10-58-01 Network Address –
Network Address
10-58-02 Network Address –
Subnet Mask
15-05-16 IP Telephone Terminal
Basic Data Setup –
Password
15-05-45 IP Telephone Terminal
Basic Data Setup-
NAT Plug & Play
15-05-47 IP Telephone Terminal
Basic Data Setup –
Registration Expire
Timer for NAT
15-05-48 IP Telephone Terminal
Basic Data Setup –
Subscribe Expire Tim-
er for NAT
84-26-01 VoIPDB Basic Setup
– IP Address
84-26-02 VoIPDB Basic Setup
– RTP Port Number
84-26-03 VoIPDB Basic Setup
– RTCP Port Number
Networking Manual
Description/Comments
Default Gateway (WAN),
PRG 10-12-07 can be set
automatically when this pro-
gram is set to 1 = Enable.
If there are other networks
connected to this system
that are not to be routed
through NAPT translations,
then these networks must
be identified in PRG 10-58.
Use this PRG to assign the
individual IP Address (e.g.
192.168.1.100) or assign the
whole network address (e.g.
192.168.1.0).
If there are other networks
connected to system that
are not to be routed through
NAPT translations, then
these networks must be
identified in PRG 10-58. Use
this PRG to assign the sub-
net mask for the IP Address
entered in PRG 10-58-01.
Assign the authentication
password for SIP single line
telephones.
Per IP Single line telephone,
enable NAT Plug and Play
so that port forwarding is
NOT required in the router
the IP single line telephone
resides behind. Effective on-
ly when PRG 10-46-14 is set
to 1 = Enable.
On a per station basis, this
setting defines the SIP reg-
istration expiry timer. If this
value is set to 0, for the ter-
minal, the value in PRG
84-23-01 is applied.
On a per station basis, this
setting defines the SIP sub-
scribe expiry timer. If this
value is set to 0, for the ter-
minal, the value in PRG
84-23-02 is applied.
Assign the IP Address for
each DSP resource on the
VoIPDB
Assign the RTP Port Num-
ber.
Assign the RTCP Port Num-
ber.
Assigned Data
0 = No (Disable)
1 = Yes (Enable)
default is 0
Assign a valid IP Address or as-
sign a valid Network Address.
default is 0.0.0.0
Assign a valid subnet mask. de-
fault is 0.0.0.0
Up to 24 characters
Default not assigned
0 = No (Disable)
1 = Yes (Enable)
default is 1
0 = User Timer in Program
84-23-01 60~65535(sec)
default is 180 seconds
0 = User Timer in Program
84-23-01 60~65535(sec)
default is 180 seconds
xxx.xxx.xxx.xxx
Default:
Slot 1 = 172.16.0.20
0~65534
Default for DSP1 is 10020
0~65535
Default for DSP1 is
10020~10083
SL2100
1 2 3
X
X
X
X
X
X
X
X
X
X
10-9