Siemens SIMATIC MOBY D System Manual page 289

11.2 Error messages and causes for MOBY D with ASM and FC/FB 45 (direct MDS addressing)
Error code
(B#16#..)
0A
0B
0C
0D
MOBY D
System Manual, 01/2010, J31069-D0147-A6-7618
Description
Another init_run was started without waiting for ready during execution of the
init_run command
not
Do set init_run cyclically

The same physical ASM channel is used in two (or more) UDT 10 structures.

Check ASM_address and ASM_channel in
init_run cannot be executed; cyclic Process image for ASM is faulty; FC/FB 45
signals timeout of process image to ASM
This error can be deactivated by writing the value #00 to address DBB 58 in UDT
10. In certain error situations, FC/FB 45 will then, however, not generate an error
message and "seize up".
ASM_address in UDT 10 is parameterized incorrectly. ASM_address may be for

wrong module.
ASM_channel setting is ≥16 or ≤0

ASM hardware/firmware is faulty.

The same physical ASM channel is used in two (or more) UDT 10 structures.

Check ASM_address and ASM_channel in
Area length error on block move for FC/FB 45.
DAT_DB does not exist or is too small. Check DAT_DB_number and

DAT_DB_address in UDT 20
Execute an init_run

An init_run was not completed correctly. The process image is not consistent.
Run init_run again

Turn ASM off and on again.

The RUN/STOP switch on the CPU was pressed rapidly several times in

succession (particularly with slow PROFIBUS DP baud rates)
The same physical ASM channel is used in two (or more) UDT 10 structures.

Check ASM_address and ASM_channel in
Alarm, error and system messages
all
UDT 10 structures.
all
UDT 10 structures.
all
UDT 10 structures.
289