Error Messages And Causes For Moby D In Combination With The Mdwapi Library - Siemens SIMATIC MOBY D System Manual

Alarm, error and system messages

11.1 Error messages and causes for MOBY D in combination with the MDWAPI library

11.1 Error messages and causes for MOBY D in combination with the
MDWAPI library
Table 11- 1
Error code
in HEX
0x00
Table 11- 2
Error code
in HEX
0x01
0x02
0x03
0x04
0x05
0x06
280
General errors
Cause, remedy
OK:
Data/parameters read or saved without errors

Control command executed

Transponder status
Cause, remedy
No transponder:
No transponder within the detection field of the reader

Transponder in detection field has been switched to silent

Error in communication between reader and transponder. The reader can no longer

detect the transponder.
Invalid data:
CRC16 checksum error in the received data

Write error:
Plausibility test of written data failed:
Attempt to write to a read-only area

Distance between transponder and read antenna too large

Attempt to write during excessive ambient noise

Address error:
The requested data lie beyond the logical or physical address range of the transponder:
The addresses lie outside the maximum address range of the transponder

The addresses lie outside the configured address range of the transponder

Invalid transponder type:
This command is not supported by this transponder:
Write or read attempt with a transponder

A specific command is not supported by the transponder.

Read error:
Plausibility test of read data failed:
Distance between transponder and read antenna too large

Attempt to read during excessive ambient noise

System Manual, 01/2010, J31069-D0147-A6-7618
MOBY D