System integration
9.1 ASM 452
9.1.4.4 PROFIBUS DP address and terminating resistor
You must remove the connector plate from the ASM before you set the
PROFIBUS DP address or connect the terminating resistor. The connector plate covers the
DIL switch. The position of the DIL switch in ASM is shown in the figure below with one
setting example for each case.
Figure 9-3
Note
The PROFIBUS DP address in ASM 452 must always match the PROFIBUS DP address
To ensure that the terminating resistor functions correctly, you must always switch both
234
Setting the PROFIBUS DP address/connecting the terminating resistor
defined in the configuring software for this ASM.
DIL switches of the terminating resistor to "on" or "off".
System Manual, 01/2010, J31069-D0147-A6-7618
MOBY D