Overview; Enabling And Disabling Snmp Traps - Ruckus Wireless SmartCell Gateway 200 Reference Manual

Overview

This document describes the SNMP management information bases (MIBs) that the
controller supports. It also describes the overall design of the controller SNMP agent.
The controller SNMP agent allows its northbound portal application to monitor the
system via SNMP GET operation and also notifies the critical events by sending
traps. The controller supports V2 community and V3 versions of SNMP. It also
supports configuring the system via SNMP SET from this release. See
SNMP V2 and V3 Configuration
NOTE: For information on how to enable SNMP traps and configure the SNMP V2
and V3 settings on the controller web interface, refer to the SmartZone Administrator
Guide.
NOTE: Refer to
NOTE: For details on alarms and events refer to SmartZone Alarms and Events
Guide.

Enabling and Disabling SNMP Traps

In the controller web interface navigate to Configuration> SCG/vSZ-H System>
SNMP Agent to either enable or disable the SNMP trap as shown in
Figure 1. SNMP Traps
If the SNMP trap is disabled, it will not send any traps to the receiver. It also does
not allow any community or a user to enable or configure the trap target address.
SCG-200 and vSZ-H SNMP Reference Guide for SmartZone 3.4, 800-71175-001 Rev A
Flow.
About This Guide for conventions used in this guide.
SNMP Configuration and Standard MIB and OID
Overview
Updating
Figure 1.
43