Snmp Agent For Aps; Limitations; Enable Snmp Agent; Option 1 - User Interface - Ruckus Wireless SmartCell Gateway 200 Reference Manual

SNMP Agent for APs

APs by default have SNMP Agent disabled. This can be changed either using the
controller's interface or CLI console.

Limitations

• Only one target notification is allowed in both SNMP v2 and v3 agents
• You can have a maximum count of three (3) each for community and user groups
• Community or users should not have the same privileges. For example:
- Read or write or notification privileges should not be enabled in two
communities
- Read or write or notification should not be enabled in two users

Enable SNMP Agent

Option 1 - User Interface

In the controller interface navigate to Configuration > AP Zone. Select AP SNMP
Options for all the APs in the controller as seen in
Privilege option - target refers to adding SNMP target notification and inform refers
to sending SNMP information notifications to the selected community.
NOTE: For AP SNMP Inform privilege option for SNMP v3 Agent is not supported.
Figure 5. Enabling SNMP options for APs
SCG-200 and vSZ-H SNMP Reference Guide for SmartZone 3.4, 800-71175-001 Rev A
SNMP Configuration and Standard MIB and OID
SNMP Agent for APs
Figure 5.
49