Updating Snmp V2 And V3 Configuration Flow - Ruckus Wireless SmartCell Gateway 200 Reference Manual
Snmp mib for smartzone 3.4
Hide thumbs
Also See for SmartCell Gateway 200:
- Command line interface reference manual (583 pages) ,
- Getting started manual (104 pages) ,
- Reference manual (39 pages)
Table of Contents
Advertisement
SNMP Configuration and Standard MIB and OID
Updating SNMP V2 and V3 Configuration Flow
Updating SNMP V2 and V3 Configuration
Flow
Using the controller web interface, you add or update V2 and V3 communities /
users and set the operation (set/get/trap) configurations, as shown in
Figure 2
and
Figure
3. On the controller web interface, navigate to Administration > Application
Status & Logs to view the SNMP logs.
NOTE:
For information on how to enable the SNMP V2 and V3 settings on the
controller web interface, refer to the SmartCell Gateway Administrator Guide.
The controller supports a maximum of eight SNMP user profiles and eight trap
destinations for SNMPv2 and SNMv3. In the previous releases this was unlimited.
Figure 2. Enabling SNMP V2
Figure 3. Enabling SNMP V3
44
SCG-200 and vSZ-H SNMP Reference Guide for SmartZone 3.4, 800-71175-001 Rev A
Advertisement
Table of Contents
Need help?
Do you have a question about the SmartCell Gateway 200 and is the answer not in the manual?
Questions and answers