Setting The System Time - Samson TROVIS 5432 Mounting And Operating Instructions

1.5

Setting the system time

The current time and date need to be set immediately after start-up and after a power failure
lasting more than 72 hours has occurred. This is indicated by the time blinking on the dis-
play. The time is already in the edit mode and can be changed directly. The first two instruc-
tions steps are then omitted.
Proceed as follows:
Note! On initial start-up and after a power failure lasting more than 72 hours, the controller
switches automatically to the operating level after the date has been set and confirmed. The
last two steps are omitted.
Note! The controller automatically switches to the operating level if the control knob is left
untouched for five minutes.
3s Switch to user level.
Display: Time.
Open time data point.
blinks.
q
Change time.
Confirm time setting.
Display: Year.
q
Change year.
Confirm year.
Display: Date (day.month) as well as day of the week
( = Mon,
q
Change date.
Confirm date.
Display: Time
q
Select End on the display.
Switch to operating level.
= Tue, ..., = Sun)
Operation
9
EB 5432 EN