Table of Contents
Advertisement
10
Installation
The controller consists of the housing section and base. The housing section contains the en-
tire electronics, the display as well as the control knob. The base contains the terminal strip.
The controller is suitable for mounting in control panels or on walls (–> Fig. 8).
Note!
An adapter is available to mount the controller on top-hat rails.
Control panel mounting
1. Press down the tongue on top of the controller.
2. Tip the housing forward and remove it from the base.
3. Make a cut-out of 138 x 92 mm (W x H) in the control panel.
4. Insert the controller housing through the panel cut-out.
5. Use the two threaded bolts located at the side of the housing and the clips to clamp the
housing in the panel.
6. Install the electrical connections in the base as described in section 11.
7. First attach the lower part of the base to the housing and then snap on the top part.
Wall mounting
1. Press down the tongue on top of the controller.
2. Tip the housing forward and remove it from the base.
3. If necessary, drill holes at the intended place using the specifications given. Fasten
base with screws.
4. Install the electrical connections in the base as described in section 11.
5. First attach the lower part of the base to the housing and then snap on the top part.
Installation
37
EB 5432 EN
Advertisement
Table of Contents
