THOMSON Omnidrive Series Installation Manual page 147

11-10 Maintenance and Troubleshooting
J1-7 to J1-14
J1-8 to J1-15
J1-9 to J1-16
5. Choose the Encoder Diagnostics command icon from OMNI LINK.
6. Choose Zero Count for both the Motor Encoder and Master Position Input.
7. Slowly rotate the encoder shaft by hand while observing the counts for both the Motor Encoder
and Master Position Input. The Motor Encoder and Master Position Input line counts should be
equal.
If you determine that the analog input is defective, refer to "Return Procedure" on page Help-7 to return
the unit.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
lowing pins:
J1-10 to J1-17
J1-11 to J1-18
J1-12 to J1-19