THOMSON Omnidrive Series Installation Manual page 117

Table of Contents

Advertisement

8-28
Application and Configuration Examples
Refer to the section "RS-232 Communication Test" on page 11-6 for troubleshooting instructions.
6. Select Read Drive Parameters from the Communications menu.
7. Verify the Drive Name and Address are correct for the drive that is being addressed.
8. Choose OK to load the drive parameters.
A motor must be selected for the parameters to load
TIP
.
9. If the message box appears that a motor must be selected, select OK. The Drive Setup window is
displayed with Motor Model selection parameter active. The motor may be selected from the
drop down box. If this message box does not appear, the motor displayed in the Motor Model
box was previously selected.
10. Select or verify the correct motor model number from the drop down Motor Model list.
11. If a message advises that the drive must be reset, choose Yes.
12. Select Indexing as the Operation Mode for the drive.
13. Choose Close to exit the Drive Set Up window.
14. Choose the Drive Parameters command icon from the Drive window and then select the
Indexing tab.
15. Enter the following values for Index 0.
Single Move Settings
Registration
8000
1
as the Batch Count
0
as Dwell
Appropriate values for Acceleration and Decelera-
tion
The Registration Distance must be longer than the Deceleration Distance or
TIP
the move will not be registered.
16. Choose Close to exit the Drive Parameters window.
17. Verify the Status indicator is green.
18. Select the I/O Configuration command icon from the Drive Window.
19. Select an appropriate digital input from the pull-down lists available as Digital Input Assign-
ments in the I/O Configuration window.
For example:
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
– Parity: None
– Stop Bits: 1
– Serial Port: COM1
as Mode
as Distance
Start Index as Input 1
Registration Sensor as Input 2.
Batched Move Settings
Registration
as Mode
8000
as Distance
8000
as Registration Distance
3
as the Batch Count
1000
as Dwell
Appropriate values for Acceleration and Decelera-
tion

Advertisement

Table of Contents
loading

Related Products for THOMSON Omnidrive Series

Table of Contents