THOMSON Omnidrive Series Installation Manual page 104

Table of Contents

Advertisement

– Data Bits: 8
– Parity: None
– Stop Bits: 1
– Serial Port: COM1
Refer to the section "RS-232 Communication Test" on page 11-6 for troubleshooting instructions.
6. Select Read Drive Parameters from the Communications menu.
7. Verify the Drive Name and Address are correct for the drive that is being addressed.
8. Choose OK to load the drive parameters.
A motor must be selected for the parameters to load.
TIP
9. If the message box appears that a motor must be selected, select OK. The Drive Setup window is
displayed with Motor Model selection parameter active. The motor may be selected from the
drop down box. If this message box does not appear, the motor displayed in the Motor Model
box was previously selected.
10. Select or verify the correct motor model number from the drop down Motor Model list.
11. If a message advises that the drive must be reset, choose Yes,
12. Select Follower: Step/Direction as the Operation Mode for the drive.
13. Choose Close to exit the Drive Set Up window.
14. Choose the Drive Parameters command icon from the Drive window and then select the Fol-
lower tab.
15. Enter an appropriate Gear Ratio as the Follower Input. The default Gear Ratio is 1:1 (motor
encoder pulses:master pulses). If a Gear Ratio of 3:1 is entered, the motor is moved 3 encoder
pulses for every incoming step pulse.
16. Choose Close to exit the Drive Parameters window.
17. Verify the Status indicator is green.
18. Select the I/O Configuration command icon from the Drive Window.
19. Select an appropriate digital input from the pull-down lists available as Digital Input Assign-
ments in the I/O Configuration window.
For example:
Follower Enable as Input 1
Not Assigned as Inputs 2 through 3.
Not Assigned as Outputs 1 through 2.
20. Choose Close to exit the I/O Configuration window.
Installation Manual for Models ODM-005, ODM-005i, ODM-010, ODM-010i, ODM-020 and ODM-020i
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Application and Configuration Examples
8-15

Advertisement

Table of Contents
loading

Related Products for THOMSON Omnidrive Series

Table of Contents