Cleaning The Mirrors #2, #3 And #4 - Trotec Speedy 400 flexx Operation Manual

5.2.2 CLEANING THE MIRRORS #2, #3 AND #4

There are two mirrors in the operating area of the laser, which may
have to be cleaned if they are soiled. To clean the mirrors, follow the
instructions below.
MIRROR #2 and #3
1. The mirrors #2 and #3 are located on the right-hand side of the machine. To
be able to access those mirrors, you must remove the right maintenance panel.
The laser must be switched off before the panel is removed!
2. The mirrors are attached by means of two Allen screws (1), which are
located on the mirror holder. Open the screws and remove the lens holder together
with the mirror. Do not touch the milled screws while doing this (2).
Make sure that you do not touch the mirror surface with your fingers as
this reduces the mirror's working life significantly.
3. Use a drop of lens cleaning liquid from the accessories box and, while
holding the mirror on an angle, flush the surface of the mirror, to wash away coarse
soiling.
4. Put the mirror on a working surface. Put some drops of lens cleaning liquid
on the mirror and leave the liquid take effect for approximately 1 minute.
5. Use a folded piece of lens cleaning tissue soaked with lens cleaning liquid
and wipe gently over the mirror only once. Use a fresh lens cleaning tissue soaked
with lens cleaning liquid each time and again wipe over the mirror only once. Then
8026 | V5.0_EN (11/2015)
Technical changes reserved
Trotec Laser GmbH
1
2
Page 49 of 62