Cleaning The Mirrors #2 And #3 - Trotec Speedy 300 fiber Operation Manual

8017 Trotec Speedy 300 fiber
MAINTENANCE

5.2.2 CLEANING THE MIRRORS #2 AND #3

There are two mirrors in the operating area of the laser, which may
have to be cleaned if they are soiled. To clean the mirrors, follow the
instructions below.
MIRROR #2
The laser must be switched off before the maintenance panel is
opened!
1. The mirror #2 is located on the right-hand side of the machine. To be able to access
mirror #2, you must remove the right maintenance panel.
2. The mirror #2 is attached by means of two Allen screws (1), which are located on the
mirror holder. Open the screws and remove the lens holder together with the mirror.
Do not touch the milled screws while doing this (2).
Make sure that you do not touch the mirror surface with your fingers as
this reduces the mirror's working life significantly.
28/07/2015 Trotec Produktions- und Vertriebs GmbH_Linzer Strasse 156, A-4600 Wels, Austria, Technical Support
tel_+43 (0)7242 239-7000, fax_+43 (0)7242 239-7380, mailto:
1
2
techsupport@troteclaser.com
44 / 54