Tables; Engraving Table (Standard Table); Vacuum Table; Cutting Table - Trotec Speedy 400 flexx Operation Manual

4.5

Tables

4.5.1 Engraving Table (Standard table)


The engraving table rests on the base
frame

The engraving table is only for engraving
heavy objects, such as metals, marble,
granite, glass, heavy wood and acrylic
parts.

4.5.2 Vacuum Table


The vacuum table rests on the base
frame.

The vacuum table is only intended for
engraving and/or cutting thin and
lightweight materials such as films, plastic
laminates, veneers, thin sheetsof wood,
paper, cardboard, and similar.

The entire surface of the vacuum table must be covered to ensure the
maximum vacuum effect

4.5.3 Cutting Table


The cutting table rests on the base
frame.

The entire surface of the vacuum table
must be covered to ensure the maximum vacuum effect
8026 | V5.0_EN (11/2015)
Technical changes reserved
It is not allowed to place Workpieces into the baseframe without a
Table attachment (e.g. Standard-, Vacuum- or Cutting Table).
This is important so no bending on the frame and impairment of the
exhaust function is possible.
Trotec Laser GmbH
Page 35 of 62