Parameter Settings - ABB IM300-I Operational Manual

Screen 45 to screen 48: Display the absolute value of the 3th quadrant
reactive energy at sharp,peak, shoulder or off-peak rate
"Eq-3" displayed on the top.The screen display is similar to screen 29.
3.3.

Parameter Settings

In the single button mode, you can enter the parameter setup mode by pressing
" " and " " at the same time, "SET" will display at the left top corner of the
screen.
3.3.1. button function in parameter setup mode

Press " ", a bit of the parameter on the screen will twinkle, and the next bit will
twinkle by pressing
value of the bit.

is the plus button, the flash bit will plus 1 when you press "

is the minus button, the flash bit will minus 1 when you press "

is the page down button and validated button. When parameter setting is
accomplished, press "
displays on the top of the screen. Press "
and press " ", the parameter will be saved , select "N" and press "
parameter will be not saved.
3.3.2. Parameter Settings
Starting interface parameter setting mode for password
confirmation. Each time you enter the parameter setting mode
are first prompted for a password, the password is displayed as
"----." Password total of four, ranging from 0000 to 9999, the
factory default is 0000.
password to cycle selection, press
positioning subtraction operation, range 0 to 9, the button to
confirm the entry is complete. Parameters can be set only after the confirmation
IM300 Intelligent Power Monitoring Instrument
again. You can press "
" to validate the parameter, and "Y--N" (YES--NO) will
" to select "Y" or "N". Select "Y"
Press to toggle between four digit
or button to choose
33
" or " " to plus or minus the
" once.
" once..
Fig 3-3-1 Password input
Fig 3-3-2 Is stored tips
", the