ABB IM300-I Operational Manual page 46

energy, as shown in fig. 3-3-23, top of the screen displays "EP" and "total" refers to
the total active energy, the base value is displayed at the bottom of the screen and the
range is from 0 to 99999999.9kWh.
creen 28：Setting the base value of total reactive energy
S
This page is used to setting the base value of total reactive
energy, as shown in fig. 3-3-24, the top of the screen shows
"Eq" and "total" refers to the total reactive energy, the base
value is displayed at the bottom of the screen and the range is
from 0 to 99999999.9kvarh.
creen 29 ： Setting the base value of A-phase active
S
energy
When wiring for the 3-phase 4-wire system, the page used
to setting the base value of A-phase energy, as shown in fig. 3-3-25, top of the screen
displays "EP", are setting the active energy,
value is displayed at the bottom of the screen and the range is from 0 to 99999999.9.
creen 30、31：Setting the base value of B/C-phase active energy
S
When wiring for the 3-phase 4-wire system, it was used to setting the base value
of B,C-phase active energy. "b" represents phase B, "c" represents a C-phase. Similar
methods of operation and the Twenty-screen display.
creen 32~34： Setting the base value of A/B/C-phase
S
reactive energy
When wiring for the 3-phase 4-wire system, it is used to
setting the base value of A, B, C-phase reactive energy. The top
of the screen shows "Eq", bottom right of the screen displays
IM300 Intelligent Power Monitoring Instrument
"a" represents the A-phase, the base
44
Fig 3-3-25 Setting the base value of
A-phase active energy
Fig 3-3-26 Setting the base
absolute value of total forward
active energy