ABB IM300-I Operational Manual page 36

password, or to stay on this page.
When entering the parameter setting screen, as this page
parameter setting is completed, press the top button
prompted to save the current screen to set the parameters as shown
in fig. 3-3-2. "Y" on behalf of YES, that is, the set parameters are
stored, "N" on behalf of NO, that is not stored parameters. Press
"Y" or "N" option, press
Select the parameters are valid after the "Y" and press the button to confirm
such as setting, then store the current parameters; if not legitimate, upper display
shows "ERR" word prompts, as shown, the parameter is not stored 3-3-3. At this point
press button to re-set parameters, scroll buttons can also be
Note: No matter which screen parameter setting page, press the button
button to exit the parameter setting mode,returns single button display mode. In
the parameter setting page, if you do not press
settings page, this page or activation button and did not press
parameter modification, then press
stored in the parameter. The screen will go back to the single button mode
automatically if there is no operation on buttons in ten minute. .
Press the top left button until the screen shows
button to scroll upward; press
the words 'DWN', press the button down
creen 1: Communication parameters settings
S
This page is used to set the IM300
communication address,
transmission format. Top of the screen displays
the word "COMM", indicating the current page
for the communications parameter setting page.
As shown in fig. 3-3-4, communication
address range is 1 to 254; baud total of 1.2k,
2.4k, 4.8k, 9.6k, 19.2kbps five kinds to choose from;
there are four kind of transmission formats: 0,1,2,3. (The details refer to 3.2.3 display
IM300 Intelligent Power Monitoring Instrument
button.
button will scroll directly, this page is not
button until the top left of the screen display after
scroll.
baud rate and
34
will be
Fig 3-3-3 Parameter error
button to make
.
button to activate the current
or
word 'UP', then press
Fig. 3-3-4 Communication
parameter settings page
,
and
button