Data Read（Non Soe - ABB IM300-I Operational Manual

In the single button mode, press the combinatorial button at the same time and
then loosen, you can enter the corresponding combinatorial button function; use the
combinatorial button again you will go back to the single button display screen
(except the fourth button combination).
3.2. Data read（non SOE）
Display content
Four rows of in the data display
field
Three at the top left corner
Current load size indication.
Digital identifier: on
off
Load character identifier
Communication status identifier
More warning signs
Switch quantization SOE identification.
10 little in data accumulated
display field
IM300 Intelligent Power Monitoring Instrument
Display measurement data, including: current, voltage, power,
power factor, frequency and so on. Second, display parameters,
SOE, time, local operations, etc.
The "a", "b", "c" denotes a ,b and C-phase respectively;
"∑"denotes summation; "Avg" denotes average; "-" denotes
minus; "n" denotes zero-sequence
Consists of English semantic abbreviations, used to indicate the
current interface meaning: such as voltage 'U', current 'I', etc.
The actual load current is relative to the percentage of rated load
current, from left to right, respectively, Ia/Ib/Ic.
The switch volume identification indicates the state of input of
the corresponding switch in 1 ~ 4(on or off).
Inductance identifier(upper) indicate inductive load
Capacitance identifier(below) indicate capacitive load
Display this identifier indicates the communication work in
normal
Does not display this identifier indicate the communication out of
work
Display this sign indicates that there is more alarm, no indication
that there is no more alarm.
Display this sign indicates that there is a switch quantifier SOE
record in memory, which does not show that there is no switch
quantifier SOE record in memory.
Display energy, temperature of the equipment and time.
13
Explanation